#CT209 View of the under side of fork crown #CT209 Finished crown, side view. Note: brass line… #CT209 Raw investment cast bottom bracket shell #CT209 Bottom bracket shell's points were removed… #CT209 Heavily modified bottom bracket shell (2009… #CT209 Heavily modified bottom bracket shell, side… #CT209 Bottom bracket shell ready for points to be… #CT209 Another view of shell before points are car… #CT209 Initial carving of long point lugs into BB… #CT209 Another view of rough cut long point lugs (… #CT209 Brass fillets to smooth the chain stay lug… #CT209 Brass fillets smooth the radius between she… #CT209 Finished bottom brackt shell showing filed… #CT209 Raw seat long point Prugnat Type-S stamped… #CT209 Unreinforced seat binder that is prone to f… #CT209 Another view of stamped Prugnat long point… #CT209 Front view of raw stamped Prugnat long poin… #CT209 Weak seat binder removed and replaced with… #CT209 Reworking seat lug (2009) #CT209 Reworked seat lug from another view #CT209 Adding brass fillets to change profile. Not… #CT209 Top view of the reworked seat biner (2009) #CT209 Reworked seat binder for rear quarter #CT209 Finished fork. Blades are single butted Rey… #CT209 Finished fork. Left blade has tube for inte… #CT209 Blade brazed to crown before clean up (2009… #CT209 Tube carrying wire through blade from near… #CT209 Tube carrying generator wire exits blade wh… #CT209 Blades are single butted Reynolds 531 Imper… #CT209 Tubing for generator wiring routing in blad… #CT209 inserting tube inside of blade for internal… #CT209 Blades inserted, but not brazed. 700x29mm t… #CT209 Modified crown with one blade set being tes… #CT209 Modified side profile of Vagner crown after… #CT209 Decorative tang being added to crown (2009) #CT209 Lightened Vagner crown with chevrons remove… #CT209 Excess steerer tube trimmed away (2009) Fork crown and steerer after brazing (2009) #CT209 Fork crown and steerer after brazing (2009) #CT209 Steerer tube inserted into Vagner crown and… 3 Vagner forged fork crowns Vagner crowns. The one in the middle has been rewo… Unpainted, partially built up for fitting, and alm… #CT209 in progress with builder, Corey Thompson (L… Chromed 105mm steel stem made by Corey Thompson.