.:madworm:.'s photos
almost done ?
| |
|
a long way to go
| |
|
imgp1996
| |
|
imgp1995
| |
|
now I hate wires
| |
|
jyetech scope - probe assembly 7/7
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - SMD parts done
| |
|
Some parts were extremely small, I guess 402 components. Soldering was challenging and my tweezers were almost too large and my left hand was shaking too much.
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - probe assembly 5/7
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - probe assembly 3/7
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - all finished: back side
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - "empty" board
| |
|
The ATmega64 + quartz + load capacitors are presoldered and flashed with the current firmware.
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - SMD parts
| |
|
Make sure D1/D7 are placed correctly. The opamps will survive the reversed zener diode (D1), but the other one (D7) is used for a boost converter which DIES if it is put in wrong.
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - other parts
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - empty backside
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - probe assembly 1/7
| |
|
There's not enough shrinking tube in the KIT, so better get some yourself.
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - probe assembly 6/7
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - probe assembly 2/7
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
jyetech scope - probe assembly 4/7
| |
|
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
