Pimped tail lights

2x RGB LED Ring, 2x AA, 1x MAX756, 1x 1N5817, 1x 22µH 3A, 1x 220µF, 2x 47µF, 1x 100nF and lots of patience.

No test drive yet. It has snowed a lot and it feels like -20°C outside. My fingers almost fell off.

And the best thing, as usual, it works with the Arduino IDE. Just pull off the cpu modules and reprogram them as you like. A 6pin FTDI compatible header is on their backsides. There's also an ICSP header, but that can only be used once to program a bootloader. After that MOSI/MISO/SCK are used for the LEDs (whole PORTB of the chip). The backplane provides power (5V) and a common bus consisting of 2 GPIO pins and of course the I2C lines. In this case I use one line for a trivial syncing routine. The boards run with the internal oscillator and that seems to vary quite a low between these two chips. Without syncing after each run, there would be significant dephasing.

Now I should really get some mudguards. Getting a wet but is one thing, but deliberately exposing hand-made electronics to a mixture of salty, dirty and half molten snow is unheard of.