JyeTech cap-meter 10nF
JyeTech cap-meter 22pF
JyeTech cap-meter + slider
Jyetech scope - improved back plate
Jyetech scope - improving the back plate
jyetech scope - fully assembled
Jyetech scope - improved back plate
jyetech scope - front panel too small
jyetech scope - front panel too small
jyetech scope
jyetech scope - all finished: back side
jyetech scope
jyetech scope
jyetech scope - fully assembled after milling
jyetech scope
jyetech scope - LCD assembled
jyetech scope - all finished: back side
jyetech scope - all done: front side
jyetech scope - LCD
This crocodile even hase eyes!
jyetech scope - 7805 regulator test
jyetech scope - 7805 regulator test
jyetech scope - only back side done
jyetech scope - probe assembly 7/7
jyetech scope - probe assembly 4/7
jyetech scope - probe assembly 3/7
jyetech scope - "empty" board
jyetech scope - probe assembly 2/7
jyetech scope - probe assembly 5/7
jyetech scope - SMD parts done
jyetech scope - empty backside
jyetech scope - probe assembly 6/7
jyetech scope - probe assembly 1/7
jyetech scope - SMD parts
jyetech scope - other parts
Jyetech - Arduino speed measurement
Tiny SMD resistor
Tiny SMD capacitor
Jyetech - replaced ATmega64
Keywords
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
89 visits
JyeTech cap-meter 1000µF
Officially it supports 1pF to 500µF with auto-ranging. It also measured a 1000µF cap, but locked up after that. Can't blame it for that I think. Auto-ranging is pretty quick with small capacitances.
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2024
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.