.:madworm:.'s photos
Good policy - wasn't implemented
| |
|
OPTO isolation slot
| |
|
Hrrrmmp!
| |
|
Argh! To put some heatshrink tubing over that, I will have to dismantle the cable. Electrical tape would be possible, but that is not a long-term fix.
Thermo couple
| |
|
I had to redo the lousy ground wire
| |
|
I tried to solder the previous wire to the metal tube, but that didn't work. It gets too hot when the thing is on. A spade connector would be ideal...
IMGP8559.JPG
| |
|
Not so safe safety-earth connetion
| |
|
Not so safe safety-earth connetion
| |
|
Doesn't stick and melts when device is on
| |
|
IMGP8557.JPG
| |
|
IMGP8553.JPG
| |
|
IMGP8558.JPG
| |
|
Misaligned bolt hole
| |
|
IMGP8550.JPG
| |
|
IMGP8549.JPG
| |
|
IMGP8552.JPG
| |
|
Should I be concerned?
| |
|
The top two wires / traces carry 220V AC. The next one is safety-earth. Then 24V DC for the fan, then 2 wires for the thermo-couple, and lastly 2 wires for a reed switch.
Let's hope those line-voltage carrying wires don't overheat and melt their insulation.
IMGP8538.JPG
| |
|
