.:madworm:.'s photos
OLS pull-up/down wing
| |
|
Now fully assembled. Works ok for me up to 100MHz + RLE. 200MHz sampling rate + RLE needs stronger pull-down resistors. With RLE turned off the 'noise' on unused channels creeping over from a used one is tolerable (for me at least).
A very interesting discussion about the problem this board tries to solve.
A LED
| |
|
A LED
| |
|
A LED
| |
|
A LED
| |
|
10mm, red.
I would very much have preferred a diffused one, although this image would probably not exist then. And is that correct grammar?
A LED
| |
|
A LED
| |
|
A LED
| |
|
A LED
| |
|
A LED
| |
|
A LED
| |
|
A LED
| |
|
A LED
| |
|
Finished MBI5168 breakout board
| |
|
I finally got the missing parts. The solder bridge has been replaced with a proper 0-Ohm resistor as well ;-)
Finished MBI5168 breakout board
Chained MBI5168 breakout boards
0.1-in female header
| |
|
I had soldered one of these onto the MBI5168 breakout boards and some sockets simply refused to accept a wire.
First I removed the springy things and replaced them with new ones. Still didn't work. Pulled them out again and the replacement parts were bent out of shape as well. Turns out the inside is f*cked up, probably some error in the molding process.
0.1-in female header - springy things
| |
|
I had soldered one of these onto the MBI5168 breakout boards and some sockets simply refused to accept a wire.
First I removed the springy things and replaced them with new ones. Still didn't work. Pulled them out again and the replacement parts were bent out of shape as well. Turns out the inside is f*cked up, probably some error in the molding process.
