Search among Tony Glen's articles

Want one like mine? www.ipernity.com/doc/286325/24577519/in/ album/365561 someone on Ebay is selling one.

This Xmas I will be back in Maryland! and I will go to Dover, DE!

Today before it started snowing I cleaned up my cross arm and brought it into the house because I got an idea that I could use it as an insulator display somewhere.

I found out that Summerland actually owns their own distribution that si fed by FortisBC's grid. Well there is the reason why I thought the poles in summerland were kinda cheesy...

I'm rapidly uploading selected photos I took over the summer so ever day I will be posting around a whole page of photos twice a day when I'm on work break.

November 29th, 2013 Will be in Calgary taking photos December 21st, 2013 Will be in Maryland.

Where Should I go? A) Ohio B) California C) Nevada These are just places I'm thinking of going to but I'm not 100% sure.

Just found out that Great Falls actually runs 12kV! But they did say back in the day it was 4.16kV wye.

It has been a long time since I have uploaded any pole drawing models, So tomorrow or Monday I will post a shot of a Baltimore Gas & Electric 33kV double circuit pole similar to this: www.ipernity.com/doc/286325/23436625/in/ album/445483

I wish PA Power Liner & Kilovolt Andrew would come to Ipernity but the problem is they have so many photos (5,000!) that they don't wanna have to import all of them over.

Other people have made albums called Best Of (Their Name) and thne put photos of their favs & old photos etc.... I'm gonna start working on one too.

I haven't made any sine I made this one: www.ipernity.com/doc/286325/24951575/in/ album/365725 And I'm about to finish a 34.5kV or 69kV dead end pole with glass disks.

the line that will feed the new sub not far from my house will most likely be tapped from this line. www.ipernity.com/doc/286325/18555143/in/ album/365567 You can see all City Of Lethbridge (My Home) Transmission & Distribution projects here:

Since I will be going to Calgary (Biggest City Near Me) I will check out the antique mall & check the smaller antique stores in Nanton too. Also the line safari called "Ghost" will be out too! I will be visiting an old substaiton where an old 1940s

I dislike the folders because I have soooo many albums! I'm just gonna name albums states/provinces instead and add all photos taken in that area to the album. For example, If I have an album named Maryland, Than all photos BGE, DPL, CEC, SMECO, PEPCO

BC has far more 69kV lines than AB.... Powerline64 only knows of three still in service & knows of two that were downgraded to distribution. Most of Alberta's electric transmission runs at 240kV & 138kV. BC on the other hand runs 230kV, 345kV,

4 weeks & I will be in Montana taking photos of pyrex in Great Falls then after that day I get on a plane to go back to Maryland! I'm flying from Great Falls, Montana to Denver, Colorado. Then from there I fly to Baltimore, Maryland. Then I will be in

If anyone ever goes to Maryland you should go check out Easton! they run an old 8320,4800 volt system in a 56 square mile area. Easton is located 20 mins from Denton & Denton is near the Sussex County, Delaware state line.

Flicky got ruined, Youtube got ruined, NOW WHAT?!

Delmarva's 12kV grid in Maryland hosts a ton of L-M cans.

Altalink is planning to build a 500kV HVDC line from Genesee power plant near Edmonton, Alberta to the Langdon substation near Calgary, Alberta. Since the transmission line I'm fed from comes from Langdon I will now be getting power from a location 6

Tomorrow I have some work to do in Calgary and I will have time to take some shots of the old Calgary Power transmission towers.

Now that I'm done my work I will go get shots of the old 115kV 1940s lattice towers.