Revenki

Revenki

Posted on 04/27/2015


Photo taken on April 26, 2015


See also...


Authorizations, license

Visible by: Everyone
All rights reserved

47 visits

Easy Part

Easy Part
Built the entire main board and control board. Now i just need to connect all of those wires to the two tiny circuit boards...

And yes, the case looks a lot better than in the previous picture - much sanding and polishing was involved.

The switches from left to right are: power, shutter hold vs. camera auto, single shot vs. continuous reset, and lightning sensor vs. external sensor. The large phono jack is for a general purpose trigger signal from whatever sensors I might come up with in the future. The small phono jack supports Aputure-style standard short remote cables (so that it will work with any Nikon DSLR). The last switch has a momentary position, as well, to "arm" the thing to watch for a flash when it's in lightning trigger mode.

Comments