Milling
01 Mar 2012
Cut down to length
I was taking a lot of passes. Either 0.1mm or 0.05mm, depending on how loud it got.
05 Jul 2013
Assembly jig
The first set of holes were of no use. After drilling I noticed that the block wasn't square enough. Depth wasn't uniform either. The 2nd set of holes did the job. It still wasn't a piece of cake, but it worked.
19 Aug 2009
Milling wood
I was trying to build a contraption that would allow me to punch circles into the white plastic foil of my Ikea SAMTID lamp. Unfortunately the wood is too soft, the punch is too dull and the plastic too tough.
This was milled in 2 steps and had to flipped over.
19 Aug 2009
Milling wood
I was trying to build a contraption that would allow me to punch circles into the white plastic foil of my Ikea SAMTID lamp. Unfortunately the wood is too soft, the punch is too dull and the plastic too tough.
The bit you see is also not long enough. I had to turn the piece over.
19 Aug 2009
Wood is soft
I was trying to build a contraption that would allow me to punch circles into the white plastic foil of my Ikea SAMTID lamp. Unfortunately the wood is too soft, the punch is too dull and the plastic too tough.
Jump to top
RSS feed- Latest items - Subscribe to the latest items added to this album
- ipernity © 2007-2024
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter