#CT209 Brass fillets smooth the radius between she… #CT209 Finished bottom brackt shell showing filed… #CT209 Raw seat long point Prugnat Type-S stamped… #CT209 Unreinforced seat binder that is prone to f… #CT209 Another view of stamped Prugnat long point… #CT209 Front view of raw stamped Prugnat long poin… #CT209 Weak seat binder removed and replaced with… #CT209 Reworking seat lug (2009) #CT209 Reworked seat lug from another view #CT209 Adding brass fillets to change profile. Not… #CT209 Top view of the reworked seat biner (2009) #CT209 Reworked seat binder for rear quarter #CT209 Extensively reworked seat lug (2009) #CT209 Finished seat binder. Fully filed. Threaded… #CT209 Another view of finshed seat lug. (2009) #CT209 Yet another view of the finished seat lug (… #CT209 Raw stamped Prugnat lugs marked up for fili… #CT209 Top view of raw stamped Prugnat head lugs (… #CT209 Bottom view of raw stamped Prugnat lugs (20… #CT209 Fillets and top point added to reshaped sid… #CT209 Added point and fillets of lower head lug (… #CT209 Added fillet to smooth the radius of the lo… Bailey with the bits of #CT209 on the stone alignm… #CT209 Another view of rough cut long point lugs (… #CT209 Initial carving of long point lugs into BB… #CT209 Another view of shell before points are car… #CT209 Bottom bracket shell ready for points to be… #CT209 Heavily modified bottom bracket shell, side… #CT209 Heavily modified bottom bracket shell (2009… #CT209 Bottom bracket shell's points were removed… #CT209 Raw investment cast bottom bracket shell #CT209 Finished crown, side view. Note: brass line… #CT209 View of the under side of fork crown #CT209 Stainless steel dropouts (2009) #CT209 Finished fork. Blades are single butted Rey… #CT209 Finished fork. Left blade has tube for inte… #CT209 Blade brazed to crown before clean up (2009… #CT209 Tube carrying wire through blade from near… #CT209 Tube carrying generator wire exits blade wh… #CT209 Blades are single butted Reynolds 531 Imper… #CT209 Tubing for generator wiring routing in blad… #CT209 inserting tube inside of blade for internal… #CT209 Blades inserted, but not brazed. 700x29mm t… #CT209 Modified crown with one blade set being tes… #CT209 Modified side profile of Vagner crown after…